Matuka Streamer

Here’s a step by step tutorial for a matuka streamer. This type of streamer is very old and you don’t see it to often in the fly boxes of the fishermen today, but the truth is, that the feathers move nicely, especially when you put some weight in the front of the fly, which causes a jigging effect.

Materials:

  • Hook: Gamakatsu F 314 # 4
  • Feathers: Keough Saltwater Grizzly Hackle, Keough Saltwater Hackle
  • Body: SLF Saltwater Dubbing white and ginger
  • Eyes: Deer Creek Gator Eyes
  • Flash: Krinkle Mirror Flash
  • UV-Resin: Deer Creek Diamond Hard Tack Free Resin
  • Weight: Lead Wire
  • Ribbing: Mono

 

Wind some lead wire around the shank and secure it with super glue.

 

Create a little dubbing ball at the end of the hook shank, tie in a saltwater hackle and wind it around. The dubbing ball pushes the fibres to the sides.

 

Tie in a piece of mono for ribbing. Split the tying thread and put the dubbing mix in the gap. Spin the bobbin to twist the dubbing. Wind the dubbing around the hook shank and brush it with your velcro .

 

Take two feathers and pull some fibres from one side as shown on the photo. Tie in the feather at the front and secure them by ribbing them with the mono. Catch the ribbing with your thread.

 

Tie in some strands of krinkle mirror on each side and do a whip finish with your thread. Take two gator eyes and put them on each side. You should use super glue to secure them. The fly is nearly finished. Just take some Diamond Hard Tack Free resin and let it run between the eyes, then cure it with your uv torch. Repeat this till the gap between the eyes is filled. This makes the fly very strong and durable.

tight lines

Holger Lachmann